What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
Last Updated: 01.07.2025 08:52

The other is “what does a “fuse” do?”
2024–10–16 [ OO OLAOYE OYEBODE ]
There are two important concepts here.
Nintendo Switch 2 owners urged not to skip crucial step setting up their new consoles - GAMINGbible
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
NASA discovers that Earth's twin planet, Venus, is not geologically dead - Earth.com
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
What is lightning?
Gut Microbiota Transplants May Cause Long-Term Imbalance - Neuroscience News
[old diagram got deleted by accident]
The bolt then partially travels down the line to your home.
The MOV will conduct when the voltage exceeds 50% of line voltage.
‘Bianca Censori Candy’ Trends as Amid New Lingerie Photos - Yahoo
First Sentence:
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
How much gold is there in the world? - Live Science
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
It seems Mohan does not understand the difference between a comment and an Answer.
This device then solves the entire problem.
For this case there are devices called Metal oxide varistors (MOV).
a photo is worth a thousand words.
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
Why don't I want to talk to my girlfriend when she loves me a lot? I feel bored.
[image of Common-mode choke]
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
At one ohm, the resistor has a maximum of 1 watt power.
Do older men realize that younger women usually do not prefer them?
(Dc diagram shown, AC is similar).
I post the exact comment here.
so, what happens?
What are the upcoming trends in artificial intelligence and machine learning?
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
In schematic diagrams this is the symbol for a fuse:
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
The third is lightning and “how it gets conducted into a home.”
One is “what exactly is in a ‘surge protector’ ? ”
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
These are simplified answers to the original question, and does not change anything I wrote above.
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
So, the voltage could go up to 500 volts, and the fuse will not open up.
This one hit behind the barn.
Now when you have a certain ac resistance, then a current flows in a loop.
but this device (an Inductor) … impedes the rapid changes in the current.
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
Here is a simplified AC power diagram.
2024–10–14 [Omar Gharbi Omar Gharbi ]
Can the fuse protect the electronic devices from lightning instead of a surge protector.
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
2024–10–10[John johnson John Johnson ]
These devices are installed between the “hot” and “neutral” and protective ground.
This is the picture of an electronic coil of wire wound around a core of magnetic material.
nine
It also is a device that limits the change in current flow.
He then asserts :
An AC voltage/ current source, and an ac inductive load.
This is 'the assistant's answer'
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
At least they know the answer if they wanted it.
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
But… the neutral is now “floating” because of the 1 ohm resistance.
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
Because the load is inductive, the current lags the voltage.(by a bit).
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
the problem then depends on "how fast does the fuse operate?".
There are three different concepts here that are getting confused.
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
Edit 2024–10.
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
Upvotes:
He then describes the function of a fuse.
But it can get overloaded, and no longer works.
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
Barnstars:
A circuit breaker is similar, but is resettable.
One
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
what exactly is a ‘surge’ protector?
but I think this circuit , shows a few more pieces.
This is where the MOV conducts again, and dissipated the energy.
eight
He then describes Rainy Season and Lightning.
What does a fuse do?
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
A fuse is a non-resetable over current circuit protector.
This is where this question deviates from being a 'generic' question, and becomes more specific.